Counting matching models…
This is a bowden pass through for the bowedentube on Voron printers. I have a 350mm sized voron and It bugged me that the spool is so far in the back. putting a hole in the side panel to pass throug the bowden was no potion because this…
The title already explains a lot. ;-) This is a GPU Riser PCB Support, which supports the slot and PCB of the riser cable. Without the backed the PCB, were the PCI-E Slot is attached to, bent quite a bit. Especially when inserting the GPU…
Here I share with you my design of a bit holder for any 18V Makita Drill. My design does have a notch so this "thing" sits properly and flush on the battery socket. I also created different sizes to store different amounts of bits. The…
This is a simple and lightweight cable strain relief, for common NEMA 17 stepper motors with permanently attached cables. I was concerned that the cables will eventually snap at the stepper's input. So I designed this strain relief to…
This is my re-design of the Hailo Waste Bin Lid Part Nr.: 1068589 I broke my old one and the replacement part was unbelievably expensive (a few years back... now, not anymore) Print with "supports on builtplate only" ! Pint in the picture…
This is a simple Camera mount to mount the Insta360 GO2 to the BetaFPV 95x Cinewhoop V2. There hasnt been one around at the time of the GO2 release. So I created my own :) Print Suggestion: Filament: TPU 98A or 96A. TPE will also work…
These are all currently available results.
