Counting matching models…
Print 2 of the leaf-green and 1 of the other files. Best assembled with glue. To get the leaves curved, you can use a heatgun and bend to shape. This was printed in PLA on Prusa Mk3 and an Ender 3. The mouth and warp pipe needs support…
Here's a video of it in action! https://youtu.be/EtTMcURcMaU A boat that you can use to propel itself using a balloon. The entry on the top of the boat fits a standard balloon but should be ziptied for best use You can also scale the…
v4 foundation is confirmed compatible with OEM baseplates. This foundation piece resolves a number of issues identified with other foundation pieces I've seen on this site, mainly: tile spacing, proper hex shape, compatibility with OEM…
See https://www.printables.com/@Dom360/collections/1929103 for more gravitrax junior pieces Update: updated models to not catch the marble if its going too slow
See https://www.printables.com/@Dom360/collections/1929103 for more gravitrax junior pieces
See https://www.printables.com/@Dom360/collections/1929103 for more gravitrax junior pieces
PETG or ABS recommended for outdoor application. Mount the unifi with the cable coming out the side
See https://www.printables.com/@Dom360/collections/1929103 for more gravitrax junior pieces
See https://www.printables.com/@Dom360/collections/1929103 for more gravitrax junior pieces
This is designed with the expectation of 2 small screw hooks and 1 bearing that is 16mm in diameter with a 5mm diameter opening in the middle. Fuselage, propellor and shaft need support from build plate. Propellor, shaft and backmotor…
All you need are 9mm dowels to make these work. They will hold the spools in a way to easily see the colours and make it easy to grab one from the middle. One set is taller than the other to allow you to easily have two rows of filament…
* Supports: * Supports only from build plate needed for boat, motor and props Supports everywhere for stand * Orientation: * The boat and stand will print well standing upright with support Props will need to be printed on its back Motor…
World Map builder has been remixed to connect using the open lock format. I have added a few tiles to it and am planning on adding more as I go. I printed mine at 75% and saw success with most items. The only 2 items that didn't print…
Tested on a galaxy s10 e, but should work with any phone with the speaker on the bottom right of the phone. Category: Mobile Phone
This is used to hold the joycon in place when changing out the shell. It allows you to have the joycon facedown without pressing any buttons or the analog getting in the way. Takes about 2 hours to print on .3mm layer height Category: Tools
Works in round holed pegboard Category: Organization
Fits large phones such as Galaxy S24 Ultra with a hard case
These are all currently available results.
