Counting matching models…
I liked the DRIDER 13 remix so much I printed it at 300%. However it looked a bit bare with just black spider parts, so I designed some armor pieces for it. The three ‘Leg’ pieces need to be printed per leg, so eight times Abdomen once,…
Four brackets for a laptop to be stowed under a desk, allowing more desk space. Back ones have a stop wall so the laptop will not slide too far in; as they are separate, they can accommodate various depths and widths.
Printed with ASA in my case, contains space for voltage regulator and a fan (not tested with the fan), alongside with power toggle and power cable inlet.
A simple stand for weighing scales to take less space in the bathroom. Pictured print is silver ABS, but given the size any material should do.
Having recently acquired two energetic cats, I discovered that a lot of my plants faint. This should keep orchids stable and fit around a standard small container snugly.
A simple model converting the Ikea mug holder into a pen holder. Two other models: Divided into three sections on top: link Divided into three sections all the way through link
Converts the mug holder into off-desk pen holder with three separate compartments. The dividers keep things a bit neater inside than the plain model with just three dividers. Requires no supports and prints flat. Other variants: no…
A simple model that makes a pen holder out of the ikea off-desk mug holder. See also a variant with dividers: link And just a simple ring: link
These are all currently available results.
