Counting matching models…
I was in need of adding a sprite extruder to my Ender 5 Plus. After looking at what everyone else did, I realized I can just simply add a back plate to hold the GT belts and remove the triangle piece that was coming from the left side of…
I got a sodastream kit with 4 bottles, and want a nice and convient way to dry them after washing. So I made this! The bottle DO hang in the air and DOES NOT touch the bottom of the drying surface. Printed with no support, 0.3 mm layer,…
A pretty close recreation of some of the popular Amazon poker gadgets that you can just download and print. I personally bought these items and decided to model and recreate them so anyone can just print them instead. Included is a custom…
In complete darkness, the Bambu Lab A1 camera can be difficult to see the bed due the brightness of the white frame. This is a simple black cover that you can place on the corner of the printer that will force the camera to brighten the…
I made this for the Milwaukee m12 installation driver. It works as a stand and a bit holder!
Here's a nice little tower (no support needed!) that will hold 16 Thirsti pods! feel free to use Meshmixer to cut down some of the tower incase you don't need to hold that many.
I was tired of Ender 5 Plus's Bl touch and CR Touch not playing well with SKR boards (~30 hours wasted in trouble shooting, including making custom circuit), got tired of it and made this. Firmware Modification Required: For SKR Boards I…
A simple no support skate holder that is strong and has a lot of clearance for various of skates. Worked on my Hockey, Figure, and Speed Skates. I'd recommend PETG would be sufficiently strong enough.
A nice little holder and drainer for Scrub daddy, mommy, and other dish scrubbers. Print in PETG and no support needed! It can drain the water to the sink as well if you place it close enough to the sink.
This a perfect fit front-facing direct drive extruder for Eryone Thinker series and ER20. I've previously used other people's direct drive mod for Eryone printers, but it never fully fitted properly. So I made this from scratch using…
A much easier to use and longer eccentric nut wrench, to adjust all those hard to reach areas!
A school I volunteer at had a lice outbreak with the kids, so I made these. Cost a few cents to print, and can be much stronger than the commercially available ones. Recommend print in PETG and light colors so you can spot the lice…
I made a somewhat optimized spool holder for 1-3kg filament. -Rod has internal channels cut out to add significant amount of stiffness during slicing. -Base requires decently small amount of material. -Uses Amazon 22x8x7mm ball bearings
Ender 5 Plus's extruder and spool holder location is horrible. So I relocated mine to the top. It takes the stock filament sensor/extruder holder plate, and make use of that and put it on top. You may need additional T slot nuts (you'll…
Needed a way to hold my skis from my shelf, so I made these. You need support, support angle=89 (Cura setting) and for bambu support angle = 1. Printed in ABS/PETG. 2 wall at 0.6mm width for wall width (using 0.4mm nozzle) and over…
These are all currently available results.
