Counting matching models…
A popular design for leveling a scope to a picatinny or similar flat-top rail. With the scope loosely mounted in the rings place the jig base flush against the rail directly beneath a flat bottom area of the scope, typically where the…
Best non weaponized door stop on the internet Designed by: ChrisMUC https://www.thingiverse.com/thing:200571 Print instructions Printed in TPU using the 'Generic FLEX' settings @.2mm layer height. WARNING: You must use glue stick or some…
Spacer that allows me to mount my UniFi switch on a full width rack. Print instructions Printed using Slic3r defaults for .2mm Generic PLA.
Print optimized construction for a simple cell phone shelf that uses size Small Command Strips. NOTE 1: You will need to duplicate and modify the support in order to have both sides. A suggested print orientation file is included in the…
A bumper/tether for a Twelve South AirFly Pro Bluetooth Wireless Audio Transmitter/ Receiver so that you don't leave it behind when leaving the airplane. (I'm totally not speaking from experience here. That would be silly). A simple…
Modified version of the cable clips so that they can support tension or loading of a pair of clips.
I wanted to print a replacement leg for a SleepNumber bed. I found this excellent model, https://www.thingiverse.com/thing:3339457 but it does not fit the MK3 build volume. Using nothing but PlusaSlicer and a little trial and error I…
Replacement for the original rubber vibration isolation feet. This print makes use of the original hardware including the nut that is glued inside. Part dimensions should be close enough to allow replacing of only one foot as needed but…
A simple tether for Chilly's 500ml water bottles. Print in TPU and stretch over neck of bottle. It should be pretty durable. Prints flat with no supports required. A great test print for TPU.
Update: Added a basic version that prints flat. No supports, easy to make. A replacement to the tether that comes with this kind of water bottle from Starbucks (see pictures). This is meant to be printed in a flexible filament and can be…
A chiller to allow you to leave the carafe out for a while without the milk going bad. This is designed specifically for the Philips/Saeco Xelsis carafe (https://espresso-experts.com/products/xelsis-milk-carafe). So far I have been able…
These are all currently available results.
