7 models
Wife needed a way to tighten thumbscrew on an embroidery hoop. Press a slotted stubby hex bit into the hole. The holder acts as a guide so the bit does not slide off the thumbscrew.
The existing silverware tray we had wasn't cutting it. We had sharp knifes mixed in with the butter knives and not enough room for the extra spoons. This was the first version I printed. Next version will we a little shorter, wider finger…
Samsung Galaxy 4 Watch Stand
Corner brackets for 2x2 wood frame shooting stand. Print to tops and two middle pieces and a few screws to hold it all together. I made the base out of scrap lumber. Just ask if you would like more pictures or measurements.
.4 Nozzle and .2 layer height and 15% infill black single is PETG and OD green is PLA+
.4 Nozzle and .2 layer height and 15% infill
These are all currently available results.
