Counting matching models…
This part will allow you to mount your M.2 SSD in a pinch when you don't have the appropriate standoffs. You can mount the printed part without using any kind of glue however it is recommended to use a very small amount of adhesive that…
This is a replacement case for the Sandisk Ultra Dual Drive Go as the original plastic shell degrades after prolonged use. For a longer life increase the layer adhesion by bumping the temp. For better results print in ABS or PETG. Please…
Printed in esun TPE-83A @ 5mm/s without supports. Although buying a new DC adaptor is most likely cheaper, there is no fun in that. Fusion 360 file is available on request due to it being a cursed abomination :)
Cable hook replacement for 20x30mm monitor arms
Just simple racks for DIMM and SO-DIMM, I have also tested this with DDR1/2/3/4 and other legacy RAM formats. There is a small plaque area on the front of each rack to facilitate labelling.
For best results I have found printing the top on the bed however this highly depends on how dialed in your support structures are, if it is too hard to remove please refer to maplebaconjulio's preferred printing orientation. (Cut out…
Cable Hook for monitor arm main pole that is 35mm in width. Print with at least 3 perimeters for integrity and 0% infill as we need some internal flex.
A simple M.2 2230 SSD holder based on M.2 2280 SSD Storage Holder 16 Count by ChOaD - Thingiverse
M3 X 20mm bolt is needed for the hinge, adjust the force required to deploy the legs by tightening the bolt. for now only the 15" XPS is tested, 13" models may not allow the front XPS foot to touch the resting surface. As for the…
Related part numbers: C2P10274 C2P10275
A paper thin lid for the Small Screw Organizer by ivndbt , as it's only one layer it's pretty flimsy however it should prevent a disaster.
These are all currently available results.
