Counting matching models…
Required Stls: 1x hinge_upper 1x hinge_lower 1x arm_upper 1x arm_lower 2x nut_block *4x plastic_spacer *The plastic spacers go in the glass cutouts to align the panel and prevent the metal screw from touching the glass. Required Hardware:…
Screen cover for the Elegoo Centauri Carbon, available with or without the Elegoo logo.
Corner covers: Cover up the gap left from removing the hinges for a better chamber seal. No additional hardware required, just reuse the screws used to hold the original hinges in place. Magnetic Door Latch: Uses 2 8x3mm magnets to hold…
Alternative nozzle wiper that uses half of a Bambu Lab a1 silicone nozzle wiper. The silicone wiper that came with the Centauri started losing bristles on my third print and I wanted a cheap replacement. I chose to use a1 wipers because…
*It appears that Elegoo has changed the design of the bracket that these were meant to mount to. Check to make sure your bracket is the same length as mine in the picture or these will not work. Small covers that can be installed to block…
Covers for the rear chute, exhaust fan, and aux fan. Covering these up will help maintain a higher chamber temperature which is helpful when printing ABS/ASA. Holes are sized for 8mm or 10mm magnets.
Case for the orange pi 3b that includes a mount for a 40mm fan. I am using a 40mm Noctua fan plugged into the gpio header. Includes cutouts for all ports and easy access to the SD card. Required Hardware: Case 4x M2 20mm SHCS 4x M2 Nuts…
Bed spacer for the V0 Kirigami bed mod. Allows you to line the bed up to the front or rear of the frame.
Screw in PSU bracket for the Voron V0.2 to alleviate the need for VHB tape. Screws in to the bottom of the front and rear extrusion. You will need to preload the nuts during frame assembly, or disassemble to mount it. Assuming no other…
Seals of the old opening for the PTFE tube that is no longer used after installing the CANVAS system. Prints in less than 5 minutes.
I changed out my GPU from a 3-slot card to a 2-slot card, didn't want to buy a new cooler and thus this bracket was born. This bracket was designed to clear the tall heatsinks of the Gigabyte b650I Aorus Ultra motherboard without…
These are all currently available results.
