Counting matching models…
I found upon first use that this blower is only really good for left handed use. When using right handed the inlet keeps getting plugged with my pants. This is a bit over kill to make sure your clothing will not obstruct the air flow but…
I like the idea of buying spool less filament. Less materials in packaging. Less waste. Less weight to ship (There is a relationship between weight transported and fuel used). I was going to print some master spools and start ordering…
This is a set of clips to hold down a DeWalt DWE7480 10" portable tablesaw. It's a compact saw but that means it is prone to shifting when ripping long material. I found it a pain to use the screw holes to secure it to my mismatched stand…
This tensioner is a one way upgrade. To install it, you'll net to remove the idler pulley and cut off the steel stud it was attached to. I did this using a hacksaw and a file. The knob is the same as my other tensioners. Use the knob from…
This is a simple cover for oscillating tool blades. I bought a package of double ended blades where the blade and part that clamps to the tool are bolted together so you can flip the blade end for end when it gets dull (These guys…
This is a round pot that has a hollow false bottom in it for drainage.
It is a cover for a backwater valve that was going inside and I needed to concrete around. I believe it was a Canplas 2" valve. I know the stores here carry two different brands of backwater valves and I couldn't see any difference in the…
This is a handle for de-bur tool blades commonly available on amazon and aliexpress however unlike the original that allows the blade to rotate freely (good for inside holes), this holds the blade with a couple of screws to hold the blade…
This is a replacement foot for the Boch TS-1000 table saw stand. The legs are steel square tubing with in ID of 28mm. This fits snugly inside the tubing just as did the original. There is a one piece foot as was the original and a two…
It was a difficult task finding new run capacitors for these motors that were the same size as the old ones. In the end I gave up and got a larger one and made this replacement cover. It's in three parts as you have to screw on the end…
This is a simple dispenser for rolls of paper from either an printing calculator or a cash register. Put the paper roll so that it comes under the roll and out the front slot. Tear along the front edge to leave a bit sticking out to grab…
These are all currently available results.
