Counting matching models…
Having long hair has its challenges, it often does not behave and makes frequent escape bids from hair elastics. I wanted to find an easy hair clip that can control thicker hair without applying any tension which might cause headaches…
This is a remix on some ideas I found for to move the LCD outside an enclosure for the PRUSA Mk3s. This specific remix allows the use of the original LCD mountings without needing to modify or reprint them. The one drawback to using the…
This is a 3D printable mould for making silicone tools for candle making. The resulting silicone mould will make 74 x 98 [mm] wax sheets with a hexagon pattern for candle making. These are perfect for rolling into sticks or for use as…
This is a turn table using the iconic ends of the Prusament spools and some spare bottom bracket bearings I had on hand. The bearing type is 6806, 30 x 42 x 7mm The assembled table is just under 30mm high and I have included in the design…
This is a low-profile filament pass-through tube for a LACK printing enclosure (50 mm thick). It is designed to hold a captive piece of PTFE tubing (4 mm ID) inside for a smooth run, and printed threads hold the assembly snug to eliminate…
Motivation: This is a material development project I started working on to develop reliable print parameters for PCL filament. PCL is unique in that it can be remoulded after heating in warm water (~ 60 [C]), and is a very tough and…
These are feed designed to hold a canvas on a wooden frame (18" x 14" x 18mm). These feet slip onto the frame and balance the canvas in landscape and horizontal orientations 10 degrees from vertical. Printed with top and bottom skin…
A new remix of my previous design, the goal is to make a more recessed, subtle mount for the LCD controller on the exterior of the LACK enclosure. This was motivated by the LCD sticking out too far and being vulnerable to being knocked.
This project was enabled by the recent “ironing” release in PrusaSlicer, allowing the 3D printing of a bath plug that actually prevents draining. I recommend either printing this solid or with a thick shell to prevent it absorbing water…
The cupholders in the Mazda 3 present some challenges for the YETI Rambler mug (14 oz). This adapter prints in two pieces and thread together, fitting nicely into the cupholder slot without restricting mug access. This adapter also…
Hello! This is the model of an enclosure I designed for the Ikea BROR shelving unit . I designed this to reduce the amount of dust that could settle on the Prusa XL, reduce drafts, and eventually to set up some air filtration system. For…
A shave bar or soap insert to allow the bar to dry inside its original container. The insert is sized to fit inside a 75 [mm] circular metal container and there are two versions with different heights: 17 and 10 [mm] heights. Let me know…
I have been inspired lately by designs based around the raster pattern for FDM tool paths and decided to make a variant of my own. Roughly 130 x 80 [mm] in X/Y so should hold most soap bars and sponges for drying.
This is an axle thread cover I made to help prevent rust when my vehicle is running winter tyres. This cover is for an M22 x 1.5mm thread. I recommend using PETG for this part. My experience is they tighten up nicely against the inner…
This is an update to my previous Yeti Rambler mug adapter. This was designed around the new Toyota Prius cupholder. Aside from these updates, it has also been widened to work with other travel mugs and cups without needing to remove the…
This is an accessory to an existing watch charging stand ( link ). I quite like the look, but I wanted to make a small plug to hide the hole for threading the USB cable through the part. Using the original STL, I was able to extract…
These are all currently available results.
