Counting matching models…
I would recommend to print it with the left or right edge on the sheet, you will need supports but it will look better. 20/02/2023 Update: the cover was a bit off by 0.3mm at the curve, however I managed to scan the shape from an original…
Some notes: Can you please leave a comment with your watch model to confirm if the design fits, I would highly appreciate it! :) Also, if the model you are looking for is not listed, I can adjust the design to any model if you are able to…
2x 8G or M4 Countersunk screw or Mounting double sided tape are required. Once installed, you can slide the charging dock into the mount.
DREMEL VersaTip 2000 Organizer
This is a Laptop mount that fit the frame of IKEA FREDDE Gaming desk. I designed the mount to fit a surface laptop 2, which is around 22.3cm wide (22.8cm when opened) so there is 5mm gap between the screen back and the desk frame. however…
For the strum, use PETG or any filament with a good layer adhesion. Also, I recommend to use enforced supports and to select surfaces as shown. For pads, TPU95A does the job but softer the TPU is, better it is.
I designed this mount to replace my previous one I used for my car, it fits a Cygnett brand mount. However, I designed it in a way you can make your own hook for any brand of arm. The hook can slide into a hole following the dimensions in…
These are all currently available results.
