Counting matching models…
Wall mount for lightsabers built at Savi's Workshop. Designed to fit both of my son's lightsabers well. One of theirs has the belt clip knob and the other does not. Mount the ring about 3/4 of the way up the blade to make it easy to slip…
I made these stands for some of my son's Lego Starfighters. There are different versions for the various logos of the Rebels, Empire, First Order, and Galatic Republic so you can match them to the Lego set. I used the bricks from cfinke's…
@fudd's excellent case for the Square Golf LM with a few quality of life improvements. I added a hole in the bottom of the case so you can easily pop the battery out if needed. Added benefit is it gives you some access from the bottom to…
Simple stand for a Lego Minifig. Helps them keep from tipping over if your display isn't fully built on baseplates. Print Settings Printer Brand: Creality Printer: K1 Rafts: No Supports: No Resolution: .2 Category: Toy & Game Accessories
Corner connector for the Red Sea DIY net covers. Print as oriented. Supports from bedplate. The area that is supported will slip inside the aluminum channels and won't be seen. Print Settings Printer Brand: Creality Printer: Ender 3 Pro…
Hyundai Ioniq5 magnet board glasses loops. Prints in two pieces. No supports needed. Print both pieces, drop in suitable magnets (magnet voids are 6mmx19mmx20mm). Add a few dabs of CA glue and slide on the top cover. The top cover has a…
Airtag mount for GOTRAX G4 electric scooter. This should also fit the G3 and GMAX Ultra since they use the same reflector. My son's left rear reflector broke off his scooter so I decided it would be a good spot for an inconspicuous airtag…
Tiller Hook for a gotrax G4. Should also fit the Ultra. This uses the original spring gate and screws. The screw holes for the spring gate are slightly undersized so you can thread the screws in with an electric screwdriver or drill. Just…
This is a water bottle holder for a golf push cart. It clips to the the little accessory knob on caddytek and clicgear push carts. Replaces the (useless at least on caddytek carts) drink holder. I have caddytek carts so it was tested with…
Trim piece for the Gotrax G4 and Max center console. Print in the orientation modeled for the best finish on the visible surfaces. You will need supports. Tree supports will come off easier, but standard supports work too.
This is a simple holder for a 30oz. Owalla Freesip Sway water bottle. It clips to the the little accessory knob on caddytek and clicgear push carts. Replaces the (useless at least on caddytek carts) drink holder. I have caddytek carts so…
These are all currently available results.
