Counting matching models…
The 2026 FIFA World Cup is approaching, so I created its mascots using AI. There are three of them: a moose, a tiger, and an eagle. I printed them with a 0.1 mm layer height, 15% Gyroid infill, and supports. I was too lazy to paint custom…
The 2026 FIFA World Cup is approaching, so I created its mascots using AI. There are three of them: a moose, a tiger, and an eagle. I printed them with a 0.1 mm layer height, 15% Gyroid infill, and supports. I was too lazy to paint custom…
The 2026 FIFA World Cup is approaching, so I created its mascots using AI. There are three of them: a moose, a tiger, and an eagle. I printed them with a 0.1 mm layer height, 15% Gyroid infill, and supports. I was too lazy to paint custom…
This candle mold is detachable, and the patterned parts can be replaced with others.The assembly of the mold is very simple, and I designed everything so that no supports are required during printing. Considering the temperature of the…
For printing the model, I chose a Z height of 150 mm, but I would recommend scaling the model even larger. The most problematic parts are the fingers and the hair. I printed it with a 0.1 mm layer height, 4 perimeters, and 15% Gyroid…
A cute 3D printed figurine of two bunnies holding a heart together. The design is perfect as a small decoration or a lovely gift. For printing, supports are required. Recommended layer height is 0.1–0.2 mm and infill around 10%. The model…
The Venus of Dolní Věstonice is a ceramic figurine of a nude woman made from fired clay, originating from the Upper Paleolithic period and dated to approximately 29,000–25,000 BC. Together with several other figurines found at nearby…
Clip tisknutý z PLA výška vrstvy 0,2 bez podpěr. Po vytisknutí je nutno zámek rozhýbat. zkoušel jsem je na cívky od Průši použít trochu síly a drží bez zámku . A na cívky Aurapol s použítím zámku. Snad se bude tento model někomu také…
These are all currently available results.
