Counting matching models…
Climbing holds/rocks made to fit kids hands, size is bigger and holes to secure them to the wall are made for one size bolds. I am using Prusa MK4S with ABS+ or PETG, walls are thicker and surface is using specific Fuzzy skin setup.…
very simple but bigger bed for maileg mouses, please resize as you wish, keep support on and infill 100%, printed with PLA
Ice scate covers. inner size 3mm. Few more models added for bettere printing and also to fit bigger and longer blade. Still tight fit, will not fall.
Vent cover with lamels, fits like glove. Supports only required for side spike triagle holders. Looks great and works wiVent cover with lamels, fits like glove. Supports only required for side spike triagle holders. Looks great and works…
Bruder JCB 5CX front black arm part, version 6, V7 is removing top sharper edges and even more impores strengh, please print with infill 100%
Simple replace for light cover, no need to use glue, it will go in and never back, fillament is PETG
Gravitrax spacer 6cm tall with hole in it, so it can be used for ball to drop through. It is made very tight (!!) and it will hold a lot in the paper plate. It is heavily modified from original, where the fitment using PLA was not good…
2 (4+) models to make cover of steering wheel center for Zetor Proxima, inner diameter 55mm, outer 62mm. I use ASA for black pieces and PETG for color logo and font, models also contain plate to visually present position of each gear.…
Stand with 2 size middle pieces, it will just click in and holds both sides in place. Works well, fitment is tight. I am using ASA for Aceton use later to get smooth finish. Infill was in my case 15%. Print was made on side, depends on…
I tried to use https://www.printables.com/model/537121-replacement-gear-for-playtive-electric-trains but this did not work for my application, printing also did not print teeth sharp enough on my MK4S with ASA. So this is new wheel made…
Cover for pipes and tubes, 2 types. 1st face is flat, 2nd is more complicated to print but contains hole for fingers.Cover for pipes and tubes, 2 types. 1st face is flat, 2nd is more complicated to print but contains hole for fingers. I…
Targets to be used under dry tile installation, to maintain exact spaces between tiles, more shapes and most important halfs for side. Print without supports. I use clear PETG, infill 10-15%.
My Wilson tennis rocket sustain some damage cause by a dog. End cover of the handle was beyond of repair. So this is the replacement part. Print is ABS, both parts, for inside I used blue one as I had it already out from drier. Take…
These are all currently available results.
