Counting matching models…
It prints upright with minimal supports, just on the flat underside of the base of the funnel, with an 8mm brim to make sure everything stays in place. There are small detent beads on the funnel clip to make it removeable, but if you…
There's a great ecosystem of Crosman air pistol 3D prints and I always wanted to accessorize my Umarex Strike Point with a folding stock. This fits onto the lugs at the back of the gun using the existing factory screws and the accessory…
My HRM-swim bumper cover finally gave up so this is a new one. This will fit onto HRM-tri, HRM-run, etc just the same. I printed it “Fake Garmin” on the build plate in TPU and didn't need supports.
Use this on your Mastercraft orbital sander for dust collection that's way better than the little box it came with. You will need to trim the little lip off the sander at the connection to get this to fit flush.
These are all currently available results.
