Counting matching models…
The original relay holder gets old and cracked with age. Fits in the factory location beside the battery near the clutch cover. Print in obvious orientation 92a TPU for best results Model has built in support for the conical plug, this is…
Must print at 101% STL dimensions are too tight otherwise. Recommend ASA or PA to prevent warping in hot interiors. Prints back down, no supports
Holes are intentionally left small for a tight fit. print in the obvious orientation.
print without supports, add brim if needed but not necessary. ASA or PA is recommended for heat resistance.
The heretic ditch lights can make whistling/wind noise when driving at high speeds. These shrouds snap into the heats sinks and eliminate the noise. 2 shrouds are needed per light. If using the lights for extended period remove the…
These are all currently available results.
