Counting matching models…
This small lidded box hold 5x NVME 2280 disks. THis was the first draft. The locking pins were too tight in the holes and the holes need to be enlarged. Printed with PLA on Elegoo Neptune 4 plus 0.2mm layer height 15% gyroid infill 3 wall…
My daughters large SOLBO light has a tendency to fall off the corner of her KURA bed midway through the night causing a loud bang. This model provides a platform for the light. It is designed for the corner on the same side as the ladder…
A neat little box I found on Thingiverse for holding D&D dice. It was designed by “BaulderArtDesign”. I have found it to be the perfect size for tweezers and a pen for geocaching. The lack of sharp edges means I will not longer get poked…
Designed this watch strap loop for my kid's iMoo Z1 watch. It is a pretty tight fit to squeeze it over the buckle. Printed with TPU with 3 walls on my Elegoo Neptune 4. Infill is N/A as the walls consume the entire volume.
We recently came into ownership of a walking stick with a particularly pointed end. This is a nightmare on our tiled (too slippery) and hardwood (leaves indents) floors. This model makes a non-slip end. The image below was a test print in…
This model was taken from Thingiverse and was original designed by the user "bryantsell". I recently purchased the Wahl Designer Corded clipper set and printed this organizer to store it.
These are all currently available results.
