Counting matching models…
Snake model with magnet slots for attaching it to the refrigerator or any other surface that a magnet will stick to. This design is a single piece and requires no supports. For those who don't want magnet slots in the snake, I've also…
This design is single piece and does not require supports, so no special settings are needed. However, I will mention a few points that can help with your print quality. Resolution: 0.1 or 0.15 Infill: 15% Print Speed: 60 Disable Z-hop…
The minimum build plate size you'll need will be 20x20 cm. Make sure you have a good first layer. Due to the small components, printing the model smaller may cause issues.
Bono is the name I chose for this model, An aquatic creature design with fins that you can print without supports. please note that you should not print this model with a layer height greater than 0.16 because there are overhangs and…
You can adjust the width of the pillar candles in the slicer. For example, you can increase the width by 15%, or scale the entire model up to maintain its original proportions.
If you've found this model, then a part of your Bosch vacuum cleaner has also unintentionally broken. Well, I have a Bosch vacuum cleaner too, and while I was using it, I noticed that the locking mechanism in the middle section was…
I needed a few stamp bases and designed them this way. I have uploaded them so if anyone finds them useful, they can use them.
These are all currently available results.
