Counting matching models…
Dillon Powder Measure Label I created this powder label to slide over the clear plastic tube on a Dillon powder drop. A label can then be inserted into the main body. I have attached a label I have created already. If you need a label…
Created to hold 223/5.56 magazines. Tested with magpul, hexamag and duramags. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 200 Infill: 38 Filament: PolyMaker PETG Category: Other
This is a simple wrench I have created to assist in opening and closing the Frankford Arsenal Tumbler. It utilizes 2x m5x50mm bolts to fasten the handle to the wrench. There are two different handles for your choosing: Slim Handle - if…
I found an OpenSCAD file for the Dillon case feed adapters and it did not work properly. I decided to re-write the file to work correctly and added labels to the case feed adapter. I have attached a few case feeder adapters for your view…
Dillon Powder Drop Seperator This sits on top of the Dillon powder drop. When pulling bullets it will allow you to easily separate projectiles out of the powder. This version allows for the Dillon lid to be set on top of the powder drop…
Need this item but lack a printer? Check it out at my store through the following link: TACustomDesign Etsy Store I've held back from listing the final enhancements made to the adapter as they are exclusively available in my store. Dillon…
This is a simple mount to hold the Dillon powder measure when not in use. Print Settings Printer: Prusa Rafts: No Supports: No Resolution: 200 Infill: 20 Filament: Overture PLA Category: Other
Frankford Arsenal kinetic bullet puller wall mount. Use to screws to fasten it to the wall. Category: Other
For those that have printed the Hornady LNL case feeder ( https://www.thingiverse.com/thing:3844226 ) and are looking for a way to hook up a case collator, This is a your solution. This will accept the Dillon case feed adapters for you to…
Print the frame as shown in the picture and check fitment. Once the frame slides in and out place a small amount of glue and seat the frame in the main body. Print as many dividers as needed. I will be adding a larger divider in the near…
The frame is made to print laying down flat and will not need supports. Slide the frame into the main body. A little glue may be needed to hold the slide in the frame. Print as many dividers as needed. I will be adding a larger divider in…
These are all currently available results.
