Double Light Switch Cover with Key Hooks
For printing make sure there is support on the bottom but not very dense support or else it would be difficult to remove
- Downloads
- 27
- Likes
- 3
- Rating
- 0
Counting matching models…
For printing make sure there is support on the bottom but not very dense support or else it would be difficult to remove
Use TPU filament so that the folgers can, can snap in and out. I print it really slowly but it would very with the printer used. Two need to be printed for to hold one can. Mount them about 5-¼" +/- 1/8".
Print with minimal supports as they are hard to remove from underneath and no-one will see them there. That's my opinion anyways lol!
A simple coat hook I made specifically to be fastened to my bench beside the man door going into my garage.
This is an elephant shaped light switch cover I made for my sister. It is a quite a bit bigger than the switch and a dual switch cover would probably work better, but hey it is doing fine. For this cover and the others make sure to use…
These are all currently available results.