Counting matching models…
here's a revamp of my previous 1:1 model A that was made in tinkercad. this one is very accurate as well as proportional! made in OnShape. Huge thanks to Marryfluffy2020 for help in testing parts! self to note: don't expect the parts to…
fedelcode type 1 model i made, going off reference photos of Newport, DE , Columbus, GA , Youngstown, NY fedelcode type 1 sirens. going off The siren wiki, the rotors are 9" wide, and using this info, imagemeter gave measurements for…
rotor, stator, and mount work on a real one HARDWARE: 7 M3 by 5 screws 2 M2 by 5 screws (for the motor) rs365 12V DC motor PRINT INFO: rotor - 100% infill, no supports stator - 100% infill, optional supports stator backplate - 20% infill,…
rest in peace Hulbert's 2nd legacy system, you will be spared through a 1/4 scale model. sircoms are not enough! disclaimer that, yes, you can put as many cells on it as you want. however, i recommend not going past 20 if put outside.…
here is a approximately ⅓ scale replica of a alertronic AL-7200. measurements aren't exact. HARDWARE: 216 M3 by 8 screws (better be prepared!) 2 4mm eyebolts 24 2" speakers (used ones with frames) PRINT INFO: horns - 20% infill, no…
HARDWARE: unknown amount - M3 by 10 screws 3x - M4 by 10 screws 1x - M4 eyebolt 1x - 8 to 8mm shaft coupler (14 by 25mm) (link below) 8x - 3/16 x 1-1/4 fender washers (Hillman H# 885521) (link below) 1x - OH SUNG microwave blower motor (a…
THE BIG THING IS HERE! the ACA Alertronic AL600R, EOWS*612, and WS-3000 are the 3 sirens i've always looked up to, and one of them be this! huge thanks to Connor B for detailed measurements, this would have not been possible without that.…
tiny HARDWARE: M2X10 screws X11 super glue 130 DC motor w/ side terminals i recommend using glue to put the brackets on the hat, then mounting them to the stator. PRINT INFO: all parts can be printed with 20% infill, supports are optional…
info for all models: supports enabled 5%+ infill
once i update my other 18" rotors, i will put them here. (edit: done) yes it was made and tested. printables mobile is just not working as of posting this. HARDWARE: 4x M3 by 10 screws 1x M3 eyebolt 1x Samsung 00029 microwave blower motor…
uses M3 screws everything can be printed at 20% infill, however print the mount and rotors and 100% infill uses a Samsung DE31-00029 style microwave blower motor uses 2 8mm to 8mm shaft couplers in the rotor (14mm by 22mm shaft couplers)…
HARDWARE: M3 by 10 screws 4x m3 eyebolts 1x Samsung 00029 microwave blower motor 1x 8mm to 8mm blue shaft coupler PRINT INFO hat - 50% infill - supports optional bottom louver - 50% infill - optional supports intake - 70% infill -…
this model is fully functional and can replace a real one, using the same hardware. this model DOES indeed reflect like a real one! i recommend using deeplee yellow PETG for best reflective effect, and for handling outdoors. HARDWARE: 2…
These are all currently available results.
