Counting matching models…
Created a 3s 18650 battery pack for the DJI FPV Goggles with slight curvature to make this more comfortable in your pocket. The hinge and latch are nicely recessed. I just used a steel pin from Ace Hardware for the hinge but had to ever…
Layer height 0.2 Infill 25% (or more if you want it heavy)
Simple little print to toss your used craft knife blades into. Toss in the trash once full. Holds about 30 blades
I have always wanted some sort of dedicated charging solution and once I saw Turtle Labs design, I took a serious liking to it, but because theirs is a bit too pricey, I decided to design my own. This is designed around the Nanuk 910…
Angle mount for your Elegoo Saturn to let excess resin drip back into the vat. Left or Right can be used, even upside down. Uses M3 x 12mm bolts This only wraps around the ball joint bolt head and can be slipped over it prior to assembly…
My take on an ESC protector. The ziptie feeds thru the ends to keep from getting cut by the props. They are a little long to also help protect your wiring These are made to work with my skids & Arm guards Skoll Badger Martian *like my Arm…
I use the Racebox Micro with a 500mAh lipo stuck to the bottom and use a small velcro to attach it to the strap of my rib protector. You'll get better metrics strapped to you and NOT the steering wheel. You can always ziptie to one of the…
Resin printing requires filtering of your cleaning solution. At work I use 2 gallons of IPA in my wash tank that needs to be filtered at the end of the week. This will fit any large bottle using the 28/400 thread (from my research is most…
Arm protector for the Badger. Has a locking tab for using a ziptie to secure to the arm Made to work with my skids and racewire protector that share one ziptie Category: R/C Vehicles
Antenna mount for the TBS Crossfire nano that fits directly underneath right in the center Category: R/C Vehicles
2 sizes to choose from 16x10mm 20x10mm A very slightly modified version of the skids used in vaughndickson's design for the marmotte. It has been made wider to accommodate the larger 4mm zip-ties & made to better fit the narrower Skoll…
Designed a tray for holding the DJI air unit perfectly in place. I left just enough room for a battery strap to squeeze in between the DJI unit and the top plate if you need a strap that far in the rear. Otherwise just place some single…
The main issue I've always had with many different ESC covers/protectors, I'd constantly cut zipties in some of the most simple crashes. So now they feed thru the ends of the protector and will not be cut by the props. This will protect…
This is a major tweak of Brizzle's Martian II Arm Guard/Soft Mount Soft mounting motors is out, so I flipped this, opened up the screw pattern and added a locking tab for a zip-tie. That way in crashes it doesn't pop off and go missing.…
I could never find a spot to securely mount my beepers on this frame. So I re-designed this cage mount with an added nest to hold either a Hellgate buzzer or even a Matek beeper. This is meant to be used on the rear mount. Only print this…
I bought the Next Level Racing Wheel Stand 2.0 knowing it had an extension that I could buy later on when I found a more dedicated spot. What I didn't know, was it comes with its own seat, but I have my heart set on another and they don't…
These are all currently available results.
