Counting matching models…
There are a lot of Yeti handle models out there. I like the two-ring ones that support the tumbler at the top and below the beltline. This one prints easily with minimal supports. It screws together with a printed-in-place screw and it…
In the US, a glass gallon jug (also half-gallon) frequently has a standard 1 ½ inch (approximate size) cap. This model is for such a cap. I made mine from PETG but I suspect it would be good in most materials. It includes a gasket (liner)…
A film holder for scanning 127 format roll-film (46mm wide) on an Epson V800-V850-V700-V750 scanner. It holds the film flat at 3mm above the glass. Tight fitting clips hold the film flat for accurate scanning. It's sized to just fit on…
This is a remake of the very fine spool made by bingusmegaballs on thingiverse. I've copied it as well as I could, added an extra slot and tooth for grabbing the film, and split it into two parts for easy printing. I adjusted the…
Two-piece film holder/guide for scanning 8x10 film on the Epson scanners that support 8x10. Main part - film guide: There are two parts to this guide. One part, called BottomGuide, is placed on the glass and an 8x10 negative will fit in…
This is a film holder for 127 film for use in the Plustek OpticFilm 120 series of film scanners. It is pre-split so it can be printed on a reasonable size printer. The two halves snap together and should be glued or taped together. I…
This little clip has a multitude of uses in my darkroom. I use it to keep prints from spilling out of the tray if I'm using a tray with running water to wash prints. I use it to keep my thermometer from falling in the liquid or falling…
What it is This is a protective frame to be used when tray-developing sheets of 4x5 film. It's intended to protect the front and back surfaces of the film from accidental scratches while you are developing it. Much x-ray film, in…
Here is a replacement part for the Olympus 35RC camera. These cameras originally used 625 mercury batteries, now unavailable (and illegal to produce). The 675 zinc-air hearing aid battery is a good replacement but requires care in…
Here are two different ways of capping off the business end of your 8x10 film holder. You may not need this, but I have some old film holders and I do long exposures. These are to prevent stray light from making it into the film holder…
Printing a lasagne film developing "apron" Most people develop their film in small tanks that have spiral reels for holding the film in place so the chemicals can reach the entire surface. However, Kodak and others used to make a…
This is an add-on for your Arca-compatible tripod plate. It does three things: provides a lip so your camera won't twist on the tripod as easily. provides a little extra thickness in case the mounting thread on your plate bottoms out in…
These are all currently available results.
