Counting matching models…
This phone stand had a route for a cable that goes through the entire print. The routing is a bit tight but easy to route regardless. This was mainly designed for bigger phones and has a 22 mm opening for the phone.
This design is made with 3d printing in mind. It uses no supports and can be printed very easily although I brim for all the parts to prevent warping and in the case of the knobs, popping off while printing. I used a usb-c Arduino pro…
Breaker mount designed to make the breaker easier to access. I used a filament swap at the text to get the two colors.
This is a cover designed for the mk4 swerve cover to prevent wires from getting inside of the gearbox. No supports.
This is the standard REV spark max holder but adapted to print easier on a printer with the text of the original mount.
These use 1/8" Dyneema chord ( https://www.mcmaster.com/4377N1-4377N12/ ) and use clips ( https://www.mcmaster.com/3913T128/ ) to connect to eyebolts ( https://www.mcmaster.com/3014T103/ ) on the robot.
These are all currently available results.
