Counting matching models…
License plate frame for your car. It's cut into two pieces so you can print it on smaller beds. Print with supports touching bed. There are two tabs on the right piece which fit into matching sockets on the left piece . Use epoxy, JB…
Holds a stack of 3x3 post it notes. Increase perimeters, or set 100% infill.
Mount a stepper motor to the aluminum extrusion of your printer. Designed to fit the OUYANG Nema 17 Stepper Motor 420mN.m 1.8 Degree with Bracket and 1M DP Cable for CNC,3D Printer(17HS4401S,1 PCS) (on amazon), but should fit many other…
This helps keep your lead screw(s) vertical. There is a cutout in the center for a bearing. One file slides into the aluminum extrusion, the other mounts onto the bolt holes on top of the gantry. I designed this for the Longer LK5 Pro,…
My print bed is too small to print the whole thing. I split the frame in half and added tabs to help reconnect.
This is a replacement gasket for a square glassware container. The F360 file is included so you can modify the dimensions to fit your own container. Print with TPU. 20% infill. 0.20mm layer height. 4 perimeters 4 bottom layers 3 top…
Print with supports and at least 20% infill.
A wrench for the belt tensioner but on my printer. I used 100% infill, but 50%+ would probably be fine. Just make the walls thicker, e.g. 1.6mm.
print this at 40% infill. I used PETG but PLA should be fine. slide the mount over one of the cross rails on your roof rack. get a M5 eye bolt + nut, put the bolt through the hole in the mount, then tighten down attach guy lines for your…
Have D rings on the corners or doors of your tent? Use this to hook on to the D ring and turn them into guy out pints which are easily removable. I sewed on ½" webbing and a line loc 3, but you could easily just tie the guy line directly…
Use a command strip (or other double sided tape) to mount this to the wall. Then stick your head/scalp scratcher inside!
These are all currently available results.
