Counting matching models…
Hi everyone. I needed a housing for a dsub37 connector as the ones i ordered dident fit so i made this. Holes are made for m3 bolts and nuts. The connector it self u need to tap the hole for m3. Hope u like it
Needed a case for a generic exacto knife with room for extra blades. The lid is held in place with 6x3 magnets in each corner. The rooms in the case has cutouts for easier access to the blades and handle.
I was in need of a simple way to mount my trigorilla board to my Hypercube 2020 extrusion so i made this. Print Settings Printer: Hypercube Evolution Rafts: No Supports: No Category: 3D Printer Parts
Casing for the Dsub 25pin connector Category: Electronics
Update 24/7-18 Needed better cooling and lower mass on the X-axis. Decided to make nozzles that press fit into the opening of the fan, this works a lot better than the previous design. Not as clean looking but that might be revised in the…
These are all currently available results.
