Counting matching models…
This is replacement feet for HP keyboards. you need to use supports for the pin to print well. Print instructions Print Settings Printer: Original Prusai3 MK3S Rafts: No Supports: Yes Resolution: 0.1 Infill: 100 Filament: Plastika Trček PLA
This is cover for Headlights on Renault megane, if you have LED lights so that electronics fit inside the cover. you ned supports for latches. it is printed on the flat side Print instructions Print Settings Printer: HyperCube by Tech2c…
i broke a fan on a motor so i designed a new one. it is 168mm in diameter and the shaft diameter is 20mm. use higher infill so it doesn't explode at high speed Print instructions Category: Replacement Parts Print Settings Printer:…
this is mount for 4 pin aviation plug. that is used for probing Z axies on MPCNC. it uses no supports, you just clear the hole for the plug. Print instructions Category: 3D Printer Accessories Print Settings Rafts: No Supports: No…
This is replacement model of gear for robot vacuum cleaner Uwant U200. Gear was printed with 4 perimeters and 50% infil Material used was PLA with a lot of PTFE grease :).
These are all currently available results.
