Counting matching models…
Build Info: Parts can be printed from PLA. Higher grade magnets will produce more power (I used N52 grade). Coils can fit 350 turns of 0.4mm enamelled copper wire, but make sure the coils aren't too large for the template. All coil turn…
Print with LW PLA in vase mode. Wingspar diameter 14mm. More info: https://youtu.be/XPXN0QejqM0
This plane is designed to be printed directly onto thin tissue paper (17gsm) to produce a lightweight glider. Printing tips: To hold the tissue paper to build plate, I used thin 2mm magnets (mine were 30x10x2mm, but they can be smaller).…
Files for the compressed air engine used in the following project: FDM printed parts: Crank Case (Front, Rear) Crank Shaft Bottle Lid Engine Mount Piston Head Cap Resin printed parts: Cylinder Head Conrod Piston Seal Mold Other Required…
Rules: -Weigh less than 50g -Cannot be assembled -Must open to accept 8mm shackle The competition was a head-to-head tug-of- war, last to break wins. We could choose between PLA, PETG or ABS depending on the opponent we were up against.…
These are all currently available results.
