Counting matching models…
This is a 2 parts quick print to attach a Spool on top of the Creality CR 10 ptiner. Use the provided steel bracket as part of the assembly. The print of each part takes About 30 to 40 minutes. Category: 3D Printer Parts
This is a simple filament guide, quick to print and easy to attach. I printed it PETG and combined it withthe spool holder i also designed for CR-10. Category: 3D Printer Accessories
I made this handle to reduce pain when carrying heavy bags. It distributes the load instead of bags that cut the fingers and stop blood flow. At 1/1 scale it is 14cm wide with a handle width of 90mm. Best print orientation would be…
This is a Vacuum Chamber optimized for Epoxy or Polyurethane mixing. You can place it on a magnetic stirrer and stir the solution while in vacuum. I printed it from PLA and tested successfully. I also made the Seal CAD to print from TPU…
I downloaded the original model and thought i could make it a bit more confortable by adding rounded edge where it contacts the face. Category: Other
It is a small table that you can attach to the bedboard. It is compatible with 4cm thick board. Compatible with IKEA beds
This is a leg extension part that lifts the Fullen 12 cm higher. I bought the fullen cabinet from ikea and then i noticed that is very low for the sink i have so i designed these legs. I uploaded a cad version where you could adjust the…
This is a suggestion to develop a new type of support that grows from the side of the printed part instead of the print bed. This could save material quantity used for support and reduce print time. I have done two tests to compare, the…
The ikea Millberget chair gets scratched and damaged on the armrest front because of constantly hitting the table. I made these gards to protect it from damage. Each needs 1 hour print with 30% infill, 2 walls, 50 mm speed. No support…
These are all currently available results.
