Counting matching models…
took his model and added square on bottom for stacking with tinkercad. I flipped it so it had open side facing up, and scaled it down to 35mm on the z, as im printing crates for my crawler trailer. I printed this on my cr-10 v3, and…
scx24 low cg batt tray with esc shelf for use with furitek motor
RC car transmitter wall mount (holder) for mounting via screw or sticky tape RC transmitter to the wall for storage. This is sized for all rc car transmitters, it may fit other transmitters, but not guaranteed. I made another model, for…
TQI Transmitter wall mount (holder) for mounting via screw or sticky tape RC transmitter to the wall for storage. This is sized for Traxxas TQI transmitter, it may fit other transmitters, but not guaranteed. I made another model, for…
Pivot mount for 24th scale teeter totter. uses a 5/8th dowel rod from bby lobby as pin
Creeper BDay cake candle holder Supports: yes, touching buid plate Walls: my preferred, 4 Infil: 20% Cura Quality: default .20 Ironing: yes, top layer only so not to create jagged posts. printer: CR-10 V3 Slicer: Cura 5.1.0 Print time:…
A case to hold 4 x camera lens for DJI phantom 4 Advanced . I used the linked model, but after printing my 34.75mm lenses wouldnt fit in the holes, so i took the bottom and resized the holes to be 34.75 after measuring 34.65mm on the lens…
Painting easel arm v2 to replace a broken arm stand.
These are all currently available results.
