14 models
Carrying case feet for the Olympia SM3. Designed as a two piece replacement that fits very firmly and doesn't require any glue. Installation: - Very easy to install, just place the “P1” foot in the case first, it will hold itself…
Replacement feet for the 1956-1959 Royal Quiet Deluxe (QDL) and the 1958-1962 Royal Futura. Modeled and tested on my 1959, 1960, and 1962 Royal Futura 800's. The last generation of the QDL used the exact same feet, so are 100% compatible.…
Feet for the Olympia SM2, SM3, and SM4. Comes in two variants for you to choose from, one of which has the alignment nubs like the original feet. Not saying one is better than the other, but wanted to give people the option. Printing: -…
Body mounts for the Olympia SM2, SM3, and SM4 typewriters. Different than the stock, and plumbing washer methods as the inner bushing has a nub for aligning the body and frame properly as they are slightly offset in order for the carriage…
Feet for the Olympia SM7 and early SM8/SM9. Material/Filament: - Designed to be printed in TPU. Best results for 70A-75A with 100% infill, higher hardness TPU will require less infill to be soft enough. If you use too high of a hardness…
Feet for the Hermes 3000 1st gen curvy, and 2nd gen boxy typewriters. Both versions are down below. Material/Filament: - Designed to be printed in TPU. Best results for 70A-75A with 100% infill, higher hardness TPU will require less…
Feet for the Continental 100 typewriter carrying case. Material/Filament: - Designed to be printed in TPU. Best results for 70A-75A with 100% infill, higher hardness TPU will require less infill to be soft enough. If you use too high of a…
Feet for the wooden box style carrying case for the Consul 1511. Designed based on my 1958 Consul 1511, I had an older 1955 Consul 1511 but it used a different, wedge style case and was incompatible with these to my knowledge File…
Feet for the Consul 1511 typewriter. I designed based on my 1958 Consul 1511. I did not test on my older 1955 so unsure if compatible with the earlier variant. Material/Filament: - Designed to be printed in TPU. Best results for 70A-75A…
Spacebar/Tab bump stop for the original Continental 100. Material/Filament: - Designed to be printed in TPU. Best results for 70A-75A with 100% infill, higher hardness TPU will require less infill to be soft enough. If you use too high of…
Feet for the original Optima Elite (not the later styles like the Elite 3). Material/Filament: - Designed to be printed in TPU. Best results for 70A-75A with 100% infill, higher hardness TPU will require less infill to be soft enough. If…
Spacebar bump stop for the original Optima Elite (not the later styles like the Elite 3). Material/Filament: - Designed to be printed in TPU. Best results for 70A-75A with 100% infill, higher hardness TPU will require less infill to be…
Feet for the Continental 100 typewriter. Two versions as the front and back are slightly different, at least on mine they were. Check if the pegs in the case that the feet snap onto are different diameters, and if they aren't then you…
Body mounts for the Consul 1511 typewriter. They are split into two pieces for this print as that makes it much easier. The thinner mount (file ending in 2) goes between the body and frame, and the thicker (file ending in 1) goes between…
These are all currently available results.
