Counting matching models…
3D Printed Replacement Nose Gear for FMS Ranger 1800mm This is a 3D printed replacement part for the nose gear of the FMS Ranger 1800mm. The original aluminum gear can easily break during rough landings, so this part provides a more…
Mount for DLE 111cc or 120cc engine ignition module. Printed in PLA with or without supports.
Mount for RCEXCL Kill Switch. Printed in PLA with supports.
GP123 Great Power Engine ignition module mount for RC plane. Printed in PLA with supports.
Exhaust cap for Great Power GP 123 Engine to avoid oil dripping on the floor or other airplanes below (if staked on a shelf). Snug fit, add a "Remove before flight" ribbon for the final touch. Can be printed in PLA, then glue the parts…
To complete the XL Curved Cowling Air Dam" by AKNick I created another Low Pressure lip for Extreme Flight Slick 580 105.5" for better engine cooling. Supports needed only for the back pressure lip with overhand over 60º angle. Can…
For AJ Aircraft Raven 92" RC Airplane. Low pressure lip to improve engine cooling with higher airflow output. Support overhand angle set to 60-70º depending on your printer.
These are all currently available results.
