Counting matching models…
This helps hold the gas pump nozzle lever while you are pumping gas and there is no latch lever. This is especially useful when you are pumping during the cold months. It has multiple steps because one size does not fit all.
I needed a knob and did not want to wait for three days to order one so, voila I designed and printed one in less than 30 minutes, and it was less than $1.00 worth of material.
If you have purchased any expensive enameled cast iron cookware you know you want to protect it by any means possible. These clips are often included with the purchase; however, they get lost and/or are not included with less expensive or…
I posted this before, but I forgot to include the .stl files so I am reposting to make them available. I have several co-workers that are using this and they love it. We all need a piece of scrap paper to jot down a quick note, and we…
I needed small envelopes to sort my resistor collection. They needed to be small, inexpensive and easy to create. Trace this onto a sheet of paper, cut it out, fold and glue the bottom and two side flaps and presto, a small envelope. The…
I liked the model but it did not snap together so I added this simple fix to the mix.
Are you tired of tossing your printouts when you know the backside is still usable? If you said yes, then turn those sheets into note paper. Take a sheet of 8.5" x 11" and cut it into four equal pieces and place them into this holder and…
This started with joule thief designs I have been working on. It then mutated into this because I work for a battery company, and we are encouraged in experimentation. It uses an over the counter, USB, single cell BMS board for charging…
I needed replacement feet, so I designed these to fix up the shelves with adjustable feet. It is a four-part system, leg insert, foot, ¼-20 bolt, and a ¼-20 nut. Print up the two parts, insert the nut into the insert and the bolt into the…
I use calipers in my cubical and needed a place to keep them other than my desktop but was still within reach. This device hangs over my cubical wall and stores my calipers safely and visible. I also have two pairs, one metal for accuracy…
I needed to repair a wall wart power supply, so I cut open the welded case. Instead of trying to glue it back together I designed this to replace the case and make it repairable in the future. All you need to finish the job are four…
I found several pairs that did not meet my requirements so following others' ideas I created my own version. I needed smooth jaws so we could grip wires without leaving dents in the insulation. I also created pivot pins to hold the…
I designed this to hold a sunshade (sheet of cardboard) to block the early morning sun that was right behind my monitor. It could be used to put up a motivational poster, family photos, etc. Simple, but I thought I would share it, maybe…
I had this old clock that was a work anniversary gift. It is not a bad clock, but it was taking up desk space. I wanted a wall clock, so I designed this to remount the clock into the ring and use the shelf hanger slots to hang the clock.…
I need my headphones handy and safe, so I used my cubicle shelf bracket to place the J-hook that holds my them.
These are all currently available results.
