Counting matching models…
Various parts for a standard ¼" x 1" spaced pegboard. Screwdriver holders, pen/pencil holders, and a sharps container. Place the pegboard mount into the pegboard, and if desired, place a small m3 nut in the back prior to installation.…
I couldn't find any models to store filament on a table or desk easily. I don't have any extra wall space, but my workbench for my printers has a nice raised “shelf” that I can use to store filament. This uses ¾" wooden dowels that can be…
Used the geometry and cooling duct design of the original, but is just a 1:1 swap out over the stock Prusa MK3 cooling fan.
Finally a logo for slow Subaru cars! The Subaru SLO is something you can put on the back of your slow Impreza, Crosstrek or Outback! Print the base in black and the letters in red or pink, or whatever color you want!
Replace the “BAUER” logo on your Harbor Freight modular rolling tool boxes with a blast from the past! Based off of the tool brand from the show “Home Improvement”, these Binford logos will class up your rolling toolbox! I've also…
Nutdriver set for a toolbox. The holder that comes in the package was just a bit too big to fit in my toolbox drawers and took up so much room I decided to draw my own up. The screw bit holders could use a bit more work as they need some…
backup battery cover plate for TI-89 graphing calculators. Most likely works for different models of TI calculators as well! Printed in 0.15mm (quality) with supports on build plate for the small overhang on the tab and to make sure the…
Replacement for your lost or broken Christmas baubles. Very simple and fast print - about 8 minutes on .2mm resolution. Squeeze the two tabs of the hanger through the slot at the top of the cap, then squeeze the tabs into your ornament.…
Modification to the original model - just combined the two files into 1 so if you have a larger printer you don't need to glue the halves together.
Contains the phone numbers for the Monarca Rapid Response Helpline and the CAIR Minnesota Legal Support Helpline. My settings for my 3D printer are as follows: Generic PLA Filament 15% infill .2mm layer height First color change at 0.8mm…
These are all currently available results.
