Counting matching models…
This is a simple jet that can be used with most 1/2 inch shower hoses. The jet can be useful for cleaning sieves or other bathroom accessories. The inner diameter is 2mm. Do not forget to use a gasket.
The bolts used for mounting push plates to Schwab toilet tanks may break after a few years. These files should be a cheap way to replace the original parts. I did not replicate the design exactly, but it works fine for me. Three screws of…
The cap design of Niveao deodorant roll-ons does not allow the roller to be placed upside down. Using this simple holder, you can flip the deodorant and get every last drop out. This print does not have any strong loads or high…
This rear lens cap is for the old Fujica X mount used in the 70s and 80s. Camera lines released with this mount include Fujica STX, Fujica AX, or Porst CR. I recommend the following print settings: Use supports for the threads. The top of…
This is a quick design to protect the underside and corners of your Altera DE1-SoC Board. M3 threads are included in the model. I used PrusaSlicer to create the honeycomb infill. Print settings: * 3 perimeters * 0 top & bottom layers * An…
A simple scoop to measure the amount of dishwasher detergent. I use this scoop to track how much detergent I shall use for prewash and the regular program without needing a scale. This scoop is calibrated for the cheap brand of detergent…
This is a basic cap to seal destilled water jugs where you have to cut off a small, easy to loose plug. Print settings are basically irrelevant, I used PLA with two walls.
These are all currently available results.
