Counting matching models…
This is a small and simple device that can be used to fuse filament together. You can finally take all those end of the spool pieces and samples of filament and combine them into enough of a roll to print something. There are two parts, a…
Pins and Tabs used for registration of multi-color relief prints. Print at least two Pins and then as many tabs as you need to do a print run. When printed the tabs should fit tight into the pins. This is by design. Depending on your…
This is a soldering aid meant to replace a breadboard when soldering header pins onto a PCB. I've added STL files that will work for a Raspberry Pi Pico, but the OpenSCAD file can be modified to work for any PCB or as a generic soldering…
Connectors to build a dodecahedron using 1/4" wooden dowel rods. Print instructions I wanted to build some dodecahedron but the connectors I found online did not work so I ended up making my own. I had to print with supports, but used my…
An OpenSCAD script for generating a strainer or sifter of various sizes. You can customize the diameter, height, wall and floor thickness, and size and spacing of holes. I needed a strainer for the slop sink in my basement. (Apologies for…
I needed a print baren for some printing (2D) so I printed (3D) one. It can be scaled a bit if you need one slightly larger or smaller. I sanded the bottom with some high grit sandpaper to get a super smooth surface, though if your…
A Vertical Lip Balm Holder you can stick onto something with double-sided tape. I made this for my car so a tube of lip balm does not lay flat and melt at a funky angle in the summer. It's also handy to have a specific place for lip balm.…
Here's a slightly oversized (aka "Chonky") Solder Spool Holder. It's large and heavy (depending on infill) so it doesn't slide around on my workbench too much. (A few rubber feet on the bottom help keep it in place.) The main part can be…
This is a stand that allows a NIIMBOT D11 Label Printer to stand upright on your desk. For some reason the device was designed with a rounded bottom, so it cannot stand upright without a stand. The OpenSCAD file is included in case you…
An SK12 rod support for a 12mm linear rod held in place with a 3mm bolt. (This is an old one I never moved over from those other sites.)
This is a printable Mould and Deckle set for making paper. You'll need some screen material and (optional but highly recommended) ¼" magnets. There are two sizes included one for 8.25" square paper, and one for 6.5" square paper. The…
A device to hold three Speedball brayers standing upright. I use two of these, one sits on my workbench where I make prints and the other sits next to the sink as a “drying rack” after I wash the brayers.
A handle and backing piece to use with a sign for a protest or other purposes. The two pieces bolt together using 8-32" bolts (or 4mm bolts) and clamp around the sign. If you have concerned about wind you can hot glue the backing piece to…
This is a wrench to tighten the large plastic nut on an arcade button. It works well with the GoldLeaf Pushbuttons from Ultimarc. (I do not know if it will work with other similar buttons from other vendors.) The OpenSCAD file is included…
This is a wrench to tighten the large plastic nut on an arcade button. It works well with the Big Dome Pushbutton from SparkFun. (I do not know if it will work with other similar buttons from other vendors.) The OpenSCAD file is included…
Back in 2012 I built a MakerGear RepRap Prusa i2 and three years late the idler block broke! I made a new one, and here it is. I'm reasonable sure no more than one other person might need this, but it's here for you if you do. This was…
These are all currently available results.
