Counting matching models…
DISCLAIMER: Adding elements to the helmet can be DANGEROUS and even ILEGAL. DISCLAIMER 2: Original 3D designer: SergiLorenzo Therefore, they must be printed on flexible material, which does not interfere with the operation of the helmet.…
Remixed from thingiverse 3023372. No need fir supports. Printed in PLA+. Nothing special needed. 20% infill is more than enought I used brims for the guides.
Busbar protector made around tipical 20x90mm for 280Ah LiFePo4. Depending on your printer, aditional supports recommended on the holes. Any material. Mines are tested and produced with PLA+
Air dryer. Boots, shoes, globes, etc. It uses any standard 80 mm fan from computers. Can chose 5v powered by usb. Two pipe sizes, 35 and 37 mm. To reuse bathroom flexible tubes, can use only one cutted in half. They are 0.50€ each. It…
Just the whitle ring my kids really like, with their names. Their sizes goes from 14 to 15 mm inside diameter, that will fit almost every kid from4 to 9 in any finger :). The letters are painted (by my kids) with dollar store nail paint.
These are all currently available results.
