Counting matching models…
My first attempt at a small-scale shock mount for 20mm pencil condenser microphones. I wanted to make this as small as possible for my Sennheiser e614 mics. The design uses rubber hair elastics to float the mic and the bases tie together…
I had issues with the mic for a Kenwood TK-290 portable radio slipping off my chest rig, so I made a clip that will securely hold it in place. Fits 1.5" (38mm) nylon straps.
Used to mount Feniex Quad surface mount lights in side windows at a 20 degree angle. Files include a hole for threading wires through on either the left side or right side. I mounted mine so the wire would always be placed near the back.…
This is a dashboard mount for an HM-152 speaker-mic for an iCom radio. Made specifically to fit in the trim of a 2016 Mazda CX-5, but uploading in case it may be useful for others!
Kickstand replacement for Spigen Pixel 8 case, remixed from Tyler's model. I found that printing it flat on the back created the best end result. Hole is tight but perfectly fits the original 1.5mm pin that came with the case without it…
The Busqueda battery headstrap for Quest 3 comes with a clip similar to this, but I wanted an additional one to manage cables for an EyeTrackVR setup. This clip is specifically for the rear part of the headstrap, but could be scaled up to…
Modified geodave's Tascam DR-100 shock mount base to use 1/4"-20 thread, so it could be mounted on a tripod.
These are all currently available results.
