Counting matching models…
Bucket Print without supports with 0.15mm or 0.20mm layer thickness. Strap Print with bed supports with 0.15mm layer thickness. Shovel Print with bed supports with 0.15mm layer thickness. Simply snap strap onto the bucket and its ready to…
Snap on roof rack for Traxxas TRX-4M Bronco.
Print (2) Ends and (1) Middle. Insert a ¼" magnet into each of the ends. Glue the middle section to one of the ends. Fits large paper towel rolls but also works with smaller rolls
Simple magnetic quick release design. Uses 1/2" x 1/8" magnet. Printed with no supports and 0.15mm layer height. Design can be easily modified for different magnet sizes upon request.
Print with no supports at 0.15mm or 0.20mm layer thickness.
Sleeve for 3 lacrosse balls. Prints without support. Model in picture made with 0.30mm layer height.
Orange slice inspired tape dispenser. Fits standard scotch tape and electrical tape rolls. Two pieces including main body and cap. Each piece can be printed without supports. Recommend 0.15 or 0.20mm layer thickness.
Prints without supports. Insert filament change at 2.60mm. Then place magnets inside using super glue. Once dry, resume print and the magnets are concealed inside.
Small fridge magnet with easy to grip handle
Minimal tape dispenser that can be set on all sides and features teeth on each corner to cut tape. Prints without supports. Recommend 0.15mm layer thickness.
These are all currently available results.
