Counting matching models…
This is a model for the Gigabyte GT 1030 (GV-N1030D5-2GL). This is specifically made for the QNAP TS-473A. I used a 0.2mm Nozzle with PETG. I recommend printing this model standing upright and using tree supports for the display output…
This is a keychain/wallmount for the flic 2 button. I sketched this up in fusion 360 and used Hatchbox filament for my prints. If you have an issue of the top not fitting tight enough scale the model down in the X and Y axis by 1 or 2%.…
Original Design: Nintendo Switch Dock Front Panel Retrofit by amazingyen Here are some of the redesigns I did to this: -Added 2 Screw Mounts (The official dock front panel has 6 posts) -Added support for screw mounts for more durability…
This is a replacement part for the joycon. I made a version with a nub to press the button without a rubber pad and one that is just flat. 0.4mm Nozzle Required PETG recommended
This is a extended shoulder button for the PiBoy dmg. I found it hard to find the buttons on the back even with the extended buttons provided, so I made my own. I would recommend printing with supports with low density, depending on your…
I made a cover for the Northridge Fix microscope. I also added a handle so it is easier to grab when a ring light is installed. I used threaded inserts for a M3x6 screw Threaded inserts: https://a.co/d/1VD609w
This is a accurate model of the Creality CR-10 Mini bed to be used for manufacturing a replacement heated bed. I made this so I can use a Silicone Heater. This makes ABS possible on the CR-10 Mini. Silicone Heater: (Silicone Heater…
I recommend printing this with clear PETG. I dont know if the LEDS are cool enough for PLA so melting might occur. Make sure to have adequate fan cooling as the stem is very small. 0.4mm Nozzle Required
These are all currently available results.
