Counting matching models…
Keychron Q11 tented bottom parts. change to 7 degrees tented keyboard. each wrist rests are optional, if you need them. M2 6mm screws 18 pcs Neodymium magnet 3mm*10mm*60mm 4 pcs (for wrist rest) rubber foot 4 pcs ( if you want to print…
M2 8mm screw 12pcs robber foot 8pcs I remade my design and reduced volume and print time. No need to remove Q11's bottom plate. they become more simple and easy assemble parts.
neodymium magnet 60*10*3mm 8pcs The magnet I bought was slightly smaller than spec and I put thin painter tape on each side to fit in square cavity. These magnets can connect with frames or Q11 directly and steady. rubber foot 24 pcs…
rubber foot 8 pcs I redesigned wrist rest to make more comfortable. They take more filament and print time but better than before. Added 25mm depth on each parts.
I redesigned my data again, adjust magic trackpad position and removed each side projection.
Sometimes, my palm accidentally touch on trackpad that on between each halves when I'm typing with my custom wrist rest. I couldn't reduce height of the center parts because it was too thin to do, I decided to remove center parts. It…
expanding 16mm Keychron knob to 24mm, easy to operating one finger. install on knob with M2 12mm screw and nut.
These are all currently available results.
