Counting matching models…
Bamboo darts are great but I wanted to what see how non-bamboo darts would perform bamboo-ed. The outcomes for me were X-shot reds then then AF greys then last the darts that came with the mpp because the heat loosened the glue and the…
These may be too flimsy for use (Thank you Gabriel_4178917 for the feedback). I myself have not printed/tried these as they were made in response to some others critiques about the legs being to short. I would recommend printing at 5…
A cover for the Terrain XL's rubber ends to be printed in two separate parts. You have to split the file into parts/objects in the slicer. If the insert is too tight you can change the tolerance in the step file. NOTE: This is not…
Just MOST of the large prints cut down to fit on 120x120 printers. All credits go to Sillybuts, I just cut up his files. For the back block you will need two heatset inserts and a m3x12 screw. Both heatsets go in the upper hole. just make…
This allows a DZ pcar to pass though. I used to run this with a 45 cm vorpal barrel but have since removed the pcar due to it running into the retaining pin, and preventing the proper seal between the barrel and turn around.
This is a horizontal mount for the few of use using a sideswipe on one side, and no spare room on the other, to put the bento under the sideswipe dock. Optionally you have to preload 1 more nut on the bottom extrusion to use the little…
These are all currently available results.
