Counting matching models…
Based on models I'd seen online, This tab sandwiches leather between two printed plates. A ring screws in through the whole assembly and acts as a finger spacer. Used 3 pieces of leather (about 1mm thick each) PDF of leather pattern…
Lyre webs for use with a Rycote INV 7 shock mount, though the adapter plug is a separate print and could be altered to fit other makes/models of shock mounts.
Small foot stool. Used #6 wood screws for assembly. Plugs can be printed, hammered in, and flushed off to the face. I wouldn't consider this load bearing, I just use it to put my feet on under my desk. Printed mine on my Anycubic Kobra…
A small and simple screwed hold-down for basic lamp cord. Doesn't put much tension on the cable as is so you can have the screw not super tight and adjust tension as needed.
A pencil extender for a Blackwing pencil. I modelled it as accurately to the real thing as possible. The version you can buy doesn't include a slot to put the eraser into, which I wanted in mine. I reflexively flip the pencil to erase so…
An Awen talisman/amulet I printed in resin, molded in hi-temp silicone and cast in pewter.
Styled after Chinese teapots. Made to fit over a diffuser I bought from Saje a few years back. This is an older model I had and is a little rougher around the edges. It works, though. Version 1. Will get to version 2 at some point…
These are all currently available results.
