Counting matching models…
The Aqua One Reefsys 326 is an amazing tank and i was able to tune it to be silent, until i turn on my wave maker. The open stand pipe leads to some gulping noises when the wave makers would push some exta water into the overflow. Fitting…
This case is part of a DIY custom aquarium controller, it could also be used for aquaponics. My setup consists of a Raspberry Pi 3, Whitebox T3 (rev 1) Pi Hat & 3 Atlas Scientific EZO stamps (pH Circuit, Conductivity Circuit & Temperature…
This will make it possible to change and adjust the clean roll mounting point allowing the unit to be installed closer to the side of a cabinet or where space is restricted. In situations where the ClariSea unit is mounted low in a sump…
Cover to protect the HIGH VOLTAGE side of a C-Lin Solid state relay.
Bracket to install a runout sensor on 3030 extrusion. Used on my RatRig v3.1 to extend hight of spool holder and fit runout sensor.
A mounting solution and HIGH VOLTAGE cover for IEC plug on RatRig.
These are all currently available results.
