Counting matching models…
The original model was a bit too deep, thus sometimes causing problems with registering presses. This one fixes that and makes the knob stay closer to the panel for improved looks.
It has 2 flaps on motherboard display outputs to prevent accidentally using them instead of the GPU, they can be easily flipped up or broken out if you need to use those.
Ender spool holder now easily horizontally printable for extra strength thanks to a flat bottom. No need for side clips.
It just snaps together. You just need to add some sponge to the top and bottom. It's a bit fragile with regular PLA, but if you are careful, you'll be fine. I used Fiberlogy's Impact PLA and it's super solid. Top cover needs supports when…
The original design didn't guide the motor and limit switch cables, which isn't required at all, but bothered me nonetheless.
I wanted to use the Mini Satsana, but I only had 50x50x10mm fans lying around. So I made this very rough modification in Tinkercad. After another couple of revisions I fixed some problems with the original model, made the new version more…
What is says in the summary
You will need 4 M8x80 socket screws. You gain about 4cm per side.
Print with the opening towards the bottom. Two version one with fully flat base for easier printing, one with a razor silhouette on it.
These are all currently available results.
