Counting matching models…
A simple gauge pod for the Nissan S13 that mounts below the dash. It replaces the oem vent assembly. fits 52mm gauges and 60mm gauges My design is a straight replacement of the oem vent assembly. no cutting, no drilling, 100% reversible.…
a fan holder / duct to hold a 120x120mm PC Fan via 18mm Standoffs above the BTT Octopus board. heatinserts to mount the fan are required
a radiator support bracket, fits Nissan S13 / 180SX / 200SX / 240SX probably also other 90s Nissans
a full set of fuel line holders to replace the rusty and brittle oem clips on your 180sx/200sx/240sx Nissan S13 4 Versions: oem replacement oem replacement but without the evap / fuel tank venting line Version with additional brake line…
another wiper pivot replacement design. two piece for prints without support.
Airbox flange to 3" (MAF delete) for Nissan S13 Ca18det
a new Version of my T1H printhead design for the RatRig V-Core 3 using a MGN12 carriage and a billet main plate. Rapido, Beacon and Orbiter 2.0 on the comparison picture you can see a EVA printhead, T1H and the new T1H2 printhead short M3…
Mounting Base Counterplate and Clamp uses M8 allthread with a welded tab added Versions without Nissan and 200SX Features
Did you remove your fuse box from the engine bay and are now realizing that the oem coolant reservoir was mounted to that fuse box? Here is your solution!
a diffusor for daylight XXL LED Bars to avoid beeing blinded by the LEDS while working in front or in the printer.
an adjustable display mount for the DFRobot 5" TFT display.
long Version. internal length 177mm long Version with separation. internal length 177mm short Version. internal length 89.5mm short Version with separation. internal length 89.5mm holder for four containers. uses 8x 6x8mm Magnets
This is a holder for two Peugeot spice mills. Intended for the use of two mills in the 18cm Version. It will probably also fit any other brand of spice mills up to a diameter of 60mm. two Versions, with and without my Logo
a simple mountainbike wallmount consisting of two shelves and a center anchor point. The anchor point uses a 16mm rope that loops around the toptube of the frame and hooks back at the center anchorpoint. shelves are optimized for 29"…
These are all currently available results.
