Counting matching models…
Needed to hang the kayak paddles when not in use. Bracket is made for the handles to snap fit and my be a bit tight for some paddles. Designed in Fusion 360, printed with PETG in Prusa MK3 with .02 nozzle.
This is a replacement foot for the KitchenAid K45SS Stand Mixer. It was printed using Ninja Flex using the Generic Flex profile with a .60 nozzle. I added a 4x18mm flange to the base to allow more of the mixers frame to contact the foot.
I broke a few of the hooks on my motorcycle's cargo net. Instead of replacing the net I ma a few replacement hook Printed in Prusament PETG
This is a simple cap for a stainless steel spout that is common on many olive oil dispensers. Printed in NinjaFlex TPU at .35mm layer height
Printed on prusa i3 mk2, .02 nozzel using hatchbox woodfill PLA. Sand and stain as needed to match target.
Quickly modeled inFusion 360 this funiture foot is .25in tall and .75 in wide. Printed in Flex with 20% infill.
Recently picked up a Sea to Summit inflatable pillow, however the filler valve is smaller than my Big Agnes inflation bag so an adapter is needed. Printed in PETG
Had to create an adapter that would allow Hippo Hands to be secured at the handle bar ends on a Suzuki V-Strom 650 XL Adventure since there is a gap between the bar weights and the hand guards. This adapter mounts on the hand guard and is…
I added an AMD RX5700XT to my open chassis PC however the GPU was too short to be fully supported on the rear support. I modeled this up in Fusion 360 and printed it with PETG at .35.
These are all currently available results.
