P
Printablesbaggins
Tool organiser for Original Prusa Enclosure
You will need two M3 screws no longer than 12mm.
- Downloads
- 276
- Likes
- 63
- Rating
- 4.89
All models
10 models
P
Printablesbaggins
Wall wrench holder
Has been prepared with the thought of making the best use of space while maintaining the visibility of key markings. You will need 45x45cm of free wall to install the whole set. As reference I have used Proxxon 21pcs. set. Print with no…
- Downloads
- 265
- Likes
- 47
- Rating
- 0
P
Printablesbaggins
Spinner 3D
More rings and quite tight fit in comparison to similar projects I saw, but now it will not fall out easy. It may require some effort to separate rings if your print will be a poor quality. I only need to spent a few minutes to loose…
- Downloads
- 191
- Likes
- 13
- Rating
- 1
P
Printablesbaggins
Twist quick relase PTFE tube connector
This is version that does not use recessed/protruding magnets to ensure alignment - I have tested that neodymium magnets are strong enough to ensure precise alignment while keeping the end of connector flat. This solution allows to easy…
- Downloads
- 165
- Likes
- 46
- Rating
- 5
P
Printablesbaggins
Wera scredriver holders with easy on rail adjustment
Install the rails on the wall, put the holders on the rail in the desired arrangement and slightly tighten the bottom screw. Anytime you can loose the screw and adjust/rearrange/add/remove single holder. Includes also some yellow chisel…
- Downloads
- 131
- Likes
- 23
- Rating
- 0
P
Printablesbaggins
Wera Joker full set organiser
Prepared to fit in typical tool drawer of roller cabinet, in my case occupied ⅓ of drawer (180x390mm). The fit is quite tight but I have no bigger room for this. It is important that wrenches should by placed centred in organiser and in…
- Downloads
- 125
- Likes
- 20
- Rating
- 0
P
Printablesbaggins
Bowden lid
allow to connect external source of filament to Original Prusa Enclosure via PTFE tube you need Bowden M10 connector
- Downloads
- 83
- Likes
- 14
- Rating
- 0
P
Printablesbaggins
Tools dawer bin set
Based on 65x65mm module (67,5mm high) but you can simply scale it to fit your needs in slicer. There is a place for up to 7mm diameter silicone rubber foots, as well as a label sticker. No need for support. Based on my experience good…
- Downloads
- 61
- Likes
- 23
- Rating
- 5
P
Printablesbaggins
Ikea PAX extra shelf support
It is possible to install parallel to standard system solution. I have also attached gcode carefully optimized for dimensions and fit. You will need M6x25 screws.
- Downloads
- 41
- Likes
- 10
- Rating
- 0
These are all currently available results.