Counting matching models…
I made this model from scratch. The original design is really good, but I wasn't satisfied with the probe holders. The walls were too thin, and the rounded bottom didn't print well and eventually snapped. Even though I redesigned the…
I made this bracket to keep my batteries in a line. It's not intended to be strong. there are stronger ones. The idea is to make them wobble less. The wall is supposed to be 1mm, but for some reason it is less than that. I could increase…
Remixed from Dunderklumpen's model
My broom didn't came with a clip so I made one. The clip fits on handle with diameter 21-22mm. I printed in PLA, but I suspect it'll deform over time. Easy fix with a hairdryer. Use tight fit model for better grip. I used 0.26mm layer…
10x1 coin cell battery case remix. you need to download the inner part from the original model . Download " CR2032_10_1_Crate.stl".
I've always admired people that can do handstand. I can't do it, so at least I can have it on my desk. Bedrock printers should reduce speed. Be careful when you remove support, the braids are fragile. I printed about 12 cm (total height)…
AMS/MMU version here: https://www.printables.com/model/1764389-washing-detergent-powder-scoop-v3-4065ml-ams I made a washing powder scoop with measure lines. Easy print, no support needed. According to Ariel instructions on the package:…
No-glue version added I made this protector to avoid snapping the latch of RJ45 connector when pulling the cable. It's not perfect - you have to glue it. The reason is print orientation - it has to be printed as shown on the image. It…
I made a soap/sponge tray with replaceable insert. One straight insert, suitable for sponge, but also works for soap. And one curved that follows the curves of a soap. I don't know how well it'll hold. It'll probably get dirty pretty…
The wrench that comes with EcoSoft water purifier is really bad. It has small handle, sharp corners and it's impossible to screw the container tight. The one i made has long handle and chamfered corners for ergonomic handling. I printed…
We had a donkey with cart in our garden and there was no one to drive it. So I printed a gnome. I used PETG, 0.4 nozzle, lightning infill. I painted with acrylic paint. I screwed it to the seat with a 4x40mm screw. The model is just the…
A friend of mine bought auger anchor for beach umbrella. The adapters were already breaking and didn't have the right size. He asked me to make him two adapters - 50mm to 32mm / 25mm / 22mm. The hole for the lock bolt is all the way…
The original tassel fell apart. I printed in PLA - there is no way it'll be worse than original. Ideally you should print in PETG, but if you only have PLA don't hesitate to use it. Worst case scenario you replace them every 3-4 years.
These are all currently available results.
