Counting matching models…
I designed v2 because the Printhead touched the wiper while auto bed leveling when used the outer borders of the printbed in v1 . Because of its size you can see everything of your status-LED-stripe. I printed it in ABS for stability and…
Simply heat up the two holes with a lighter and then slide it over the rods and let it sit for 5s. check out v2!
a cover for 12VHPWR GPU cable no supports needed I printed it in PLA
clamp / holder for motorbikes and scooters with 10mm mirror rods i.e. as quadlock mount print it in PCTG, PETG or ABS with 3 perimeters and 25% infill with gyroid infill pattern, I recommend using support parts also needed: 2 x M3 15mm…
print it in TPU with 0 top and 0 bottom layer and 35% zigzag infill
OPEL Meriva B Hutablage Welle als Ersatz fuer den original Stift
Curtain Wire Fastening (see pictures) screw an M3*10 into the hole in the bottom of the fastening and thru the round wire case
only a sticker for the genius Raspberry Pi 3 Case with Homematic RPI-RF-MOD by uepsi print it - i.e. in multicolor and stick it in your Case
a Box for Fuses with the Vespa Logo on it needs support
This is a cap for PWM Ports (Molex 47054-1000) i.e. for open connectors of a PWM-splitter.
These are all currently available results.
